3/4" (1.9 Cm) Raised Grille Panel Routing - Monogram ZKFN Instructions D'installation

Design Guide - Flush Inset Installation for

3/4" (1.9 cm) RAISED GRILLE PANEL ROUTING

For 3/4" (1.9 cm) raised grille panel, routing is required. The router depth is 1/4" (0.63 cm) all the way around the
panel back. Additional panel width reductions are required per the diagrams below. This will create a "picture frame"
routing that will slide onto the attached grille trim.
TOP
Back Front
BOTTOM
3/4" PANEL SIDE VIEW
(AFTER ROUTING)
LEFT
SIDE
NOTE: For panels constructed with rails and stiles (5-panel), the minimum width is 3" (7.62 cm) for rails and 4" (10.16 cm)for stiles.
31-1000454 Rev. 0
Bottom Freezer Refrigerator
DETAIL TOP
1-11/16"
3/16"
DETAIL BOTTOM
DETAIL
LEFT SIDE
ROUTER DEPTH 1/4"
2-1/16"
3/4" PANEL BOTTOM VIEW
(AFTER ROUTING)
NOTE: Routed areas should be
finished as they may be visible
when assembled.
Back
CORNER VIEW SHOWING
"PICTURE FRAME" ROUTING
Front
Back
29
Front
DETAIL RIGHT
SIDE
ROUTER DEPTH 1/4"
2-1/16"
RIGHT
SIDE