Customization Basics; Refrigerator Location; Optional Accessory Kits - Monogram ZIC360NHLH Instructions D'installation

Design Guide - Standard Installation

CUSTOMIZATION BASICS:

Framed Or Overlay Panels, Custom
Handles and Accessory Kits
These refrigerators are designed to be customized with
decorative panels. Field installed custom door and grille
panels are required.
Side Panels
Side panels must be used whenever the sides of the
refrigerator will be exposed.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.

OPTIONAL ACCESSORY KITS

• ZKHCSS2: Monogram Tubular Stainless Steel
handles designed to fit 3/4" (1.91 cm) overlay panels.
This kit also includes a handle side trim for custom
handles.
• ZKHPSS1: Professional Tubular Stainless Steel
Handle designed to fit 3/4" (1.91 cm) overlay panels.
Kit includes one handle. Order 2 kits for bottom-
freezer refrigerators from your Monogram supplier.
• ZUG2/ZUGSS2: For side-by-side installation of two
trimmed bottom-freezer refrigerators. This kit provides
for the installation of a unified custom grille panel to
span the width of two units using a framed or overlay
panel.
• ZKHCT: Handle side trim for left-hand and right-hand
doors. For use on 3/4" (1.91 cm) custom panels when
using a custom handle.
8
31-49142 Rev. 2