General Information - Ducati MULTISTRADA V4 S 2021 Manuel D'utilisation

system technological limits that are called the
system functional limits, see the dedicated section),
alerts the rider to the presence of vehicles
approaching the motorcycle or in the blind spots.
The warning to the rider is given by the lighting of
special LEDs located on the mirrors. The LED on the
left mirror provides the indication referred to as the
left blind spot; the LED on the right mirror provides
the indication referred to as the right blind spot.
Depending on the situation, the BSD's function can
provide two levels of signaling: information warning
on the presence of vehicles (level 1) or a danger
warning signal (level 2).
Level 1: Information
If the turn indicator is not switched on, the BSD
provides information to the rider about the presence
of vehicles detected in blind spots or vehicles about
to enter blind spots which are classified as critical.
The LED on the mirror on the affected side will light
up steadily.
Level 2: Hazard Warning
If the turn indicator is already on or is switched on,
the BSD provides a hazard warning of the possible
presence of vehicles detected in blind spots or that
g
are about to enter blind spots and which it classifies
as critical. In this case, the LED on the mirror on the
side of the turn indicator switched on will flash
quickly.
If this happens, special care must be taken and the
traffic conditions at the side and/or rear must be
checked.
Note
The level 1 LED brightness is lower than the
level 2 LED brightness. You can adjust the brightness
of the LEDs on the mirrors (see section "Adjusting
the brightness of the LEDs").

General Information

The BSD is available at speeds over 25 km/h
(approximately 15 mph).
31
31
g