Setting The Preset Time; Eco Mode - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 78
Instructions for use for the user

9.13. Setting the preset time

The preset time can be set in hours (1 to 24).
The controller must be set to standby mode for this.
Press the On/Off
► The time that was most recently set flashes in the display
Select the preferred preset time using the Minus 5 and Plus 6
buttons (OFF, 1–24).
Press the Mode button 7 to switch to FIN or HUM mode and press the On/Off
button 4 to confirm.
► The display
► The standby
After the time has elapsed, the selected operating mode starts.
After a power failure or if the sauna is switched on manually, the preset
time is deactivated

9.14. ECO mode

ECO Mode ensures that the cabin temperature is the same when you come back
after a break. The following modes are available:
ECO20 for a 20 minute sauna break
ECO40 for a 40 minute sauna break
ECO60 for a 60 minute sauna break
The controller must be set to HUM mode for this.
Press the Mode button
► The display
► The standby
Press the Plus
6
Use the Minus 5 and Plus 6 buttons to select the preferred ECO mode (OFF,
E20, E40, E60).
Press the Mode button
and Plus
4
6
shows the selected preset time.
1
and timer
8
until the temperature indicator lamp
7
shows the selected temperature.
1
and temperature
8
and Minus
5
to confirm the selection and start the break.
7
buttons simultaneously for 3 seconds.
indicator lamps light up.
a
indicator lamps light up.
9
buttons simultaneously for 3 seconds.
p. 30/38
.
1
lights up.
9

Publicité

Table des Matières
loading

Table des Matières