Fuses; Temperature Correction - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Instructions for use for the user

12.2. Fuses

Fuses for the electronics and light are located in the connection area of the basic
module. They can be ordered with the item number 1-30-174 (pack of 10).
There is a fuse for the fan on the expansion board.

12.3. Temperature correction

It is possible to correct the displayed temperature value. This is possible within
a range of -9 °C/+9 °C.
The controller must be set to HUM mode for this.
Press the Mode button
Press the Plus
6
► OFF flashes in the display
Press the ON/OFF
► 0 flashes in the display
You can now adjust the displayed temperature value using the Plus
Minus buttons (Δ t: -9 to +9 °C).
5
Fig. 7: Temperature correction
until the temperature indicator lamp
7
and Minus buttons simultaneously for 3 seconds.
5
1
and Mode
4 7
(= default)
1
.
buttons simultaneously for 3 seconds.
p. 36/38
lights up.
9
and
6