Installation instructions, only for experts
Note "5. Electrical connection" on page 17 and "7.1. Connec-
tion diagram of basic module" on page 23 and "7.2. Connection
diagram for the expansion board (optional)" on page 24.
5.1. Connecting the power supply cable and heater
1. Guide the power supply and heater cable through the bushings
into the 230 V/400 V connection area
2. Connect the cables to the corresponding terminal strips
Follow the operating instructions for each device.
5.2. Connecting the evaporator (optional)
1. Guide the evaporator cable (optional with expansion board) through
the bushing
2. Connect the cables to the corresponding terminal strips
Follow the operating instructions for the evaporator.
If the evaporator does not have an automatic low-water indicator, use
a jumper to connect terminal "U1" to terminal "WM" or change the setting
of the acoustic signal (see Page 31).
5.3. Connecting the control unit
1. Guide the control unit connection cable through the bushing
low-voltage connection area
2. Connect the plug of the RJ-10 cable to the connection socket
The wave.com4 11 kW sauna controllers allow up to 4 control units to
be operated on one power unit. Use the Y-adapter (see "3.3. Optional
accessories" on page 9) to connect the optional control units.
into the 230 V/400 V connection area
k
.
1
.
j
p. 18/38
and
4
5
and
.
2
6
.
1
.
l
into the
e
.
c