Installation Instructions, Only For Experts; Installing The Expansion Board (Optional); Installing The Control Unit - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 78

Installation instructions, only for experts

4.4. Installing the expansion board (optional)

1. Connect the expansion board to the base board using the pre-configured
cables (L-N-PE) and the ribbon cable.
2. Fasten the expansion board in place using the screws provided.
Expansion board
WC4-H-PCB
(optional)
Fig. 2: Wave.com4 11 kW power unit

4.5. Installing the control unit

Install the control unit
unit
. Pay attention to how the data cable is routed.
1
ATTENTION!
Damage to the unit
● The control unit
● Only use a manual screwdriver for installation. Using a cordless screwdriver
may irreparably damage the housing.
For installation inside the sauna cabin, maintain a distance of at least 30 cm
to the ceiling.
1. Cut the recess for the control unit, for example using a Ø 70 × 35 mm hole
cutter.
2. Connect the 4-pin plug to the RJ10 socket on the control unit.
3. Screw the housing to the cabin wall by screwing the 4 wood screws supplied
through the hole.
on the cabin wall no more than 10 metres from the power
2
for the sauna controller is splash-proof (IP code IPX4).
2
p. 14/38
Basic module
WC4-B-11

Publicité

Table des Matières
loading

Table des Matières