Quick-Start; Operation At Selected Time - Sentiotec K2-NEXT Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29
Figure 4
6

Quick-Start

6.1 Turning on the control
Turn on the control according to chapter 5.1.
6.2 Adjusting and starting the control
1. Set the desired temperature using the knob 3.
Note (with a pencil mark) the temperature most
agreeable to you.
2. Briefly press time key 6 (less than 2 seconds)
• The heater starts.
• The signal lamp 1 is lit constantly.
If the cabin temperature measured is less than the
desired temperature set, the stove will be respond.
The stove will heat.
If the cabin temperature measured is greater than the
desired temperature set, the stove will not be respond.
6.3 Turning off the control
Turn off the control according to chapter 5.2.
WE DO IT FIRST.
Instructions for use for the user
7

Operation at selected time

7.1 Turning on the control
Turn on the control according to chapter 5.1.
7.2 Setting the desired time
You can set the time, after which the stove is to start
heating. You can set the time at a minimum of 15 mi-
nutes (display 00.15), or at a maximum of 23 hrs. and
45 minutes (display 23.45).
NOTE - Optional sauna door safety-moni-
tor:
After setting the desired time, the sauna door will be
monitored (refer to chapter 3) to safeguard against
fire hazards.
1. Press and hold time key 6.
• The desired time is reset to zero and from thereon
will count at 15 minute increments.
2. Release the time key 6.
• The display 2 indicates the desired time.
• The time set starts and the remaining time until the
stove will start is indicated.
3. Set the desired temperature using the knob 3.
Note (with a pencil mark) the temperature most
agreeable to you.
After the desired time set has elapsed the stove will be
started. If the cabin temperature measured is less than
the desired temperature set, the stove will be respond.
The stove will heat.
If the cabin temperature measured is greater than
the desired temperature set, the stove will not be re-
spond.
7.3 Cancelling the desired time
1. Briefly press the time key 6.
• The desired start-time will be cancelled.
7.4 Turning off the control
Turn off the control according to chapter 5.2.
P. 9/14
EN

Publicité

Table des Matières
loading

Table des Matières