Sauna Operating Modes; Sensor Operating Modes - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Instructions for installation and use

3.5. Sauna operating modes

Sauna mode
Dry heat is provided in sauna mode. The temperature in the cabin is high (80 to
100 °C). The humidity is low (no more than 10%).
Combined mode (optional – with expansion board)
In combined mode, the evaporator operates along with the heater. The temper-
ature in the sauna cabin is lower (around 40 to 65 °C) than in sauna mode, but
the relative humidity is much higher, ranging from 35% to 70%. The maximum
humidity that can be set depends on the temperature of the sauna. The higher
the sauna temperature, the lower the maximum humidity level that can be set
(see Fig. 1).

3.6. Sensor operating modes

The wave.com4 11 kW sauna controller can be operated with one, two or three
sensors.
Single sensor mode (F1)
Single sensor mode is the factory setting.
In single sensor mode, the sauna controller is operated with the heater sensor
with overheat cut-out only.
The sauna controller displays the actual temperature by default. The target
temperature is displayed while the setting is entered.
In single sensor mode, the maximum humidity that can be set (optional – with
expansion board) is based on the temperature above the heater and the humidity
is timed. Only the setpoint for the humidity (in % relative humidity) is shown on
the sauna controller display. The actual humidity in the sauna cabin when the
humidity is timed depends on the size of the cabin and the evaporator output,
and may differ from the setpoint.
100
90
80
70
60
50
40
30
20
10
0
0 10 20
Fig. 1: Characteristic curve showing humidity relative to temperature
30 40 50 60 70
Temperature [°C]
Temp
80 90 100 110
p. 11/38
EN