Instructions for installation and use
9. Operation
Observe "8. Operating and display unit" on page 25.
9.1. Switching on
Switch on the controller by switching on the external main switch (optional).
► The standby indicator lamp
9.2. Setting the heating time
The heating time can be set in hours (1 to 12).
The controller must be set to standby mode when this is programmed.
Press the On/Off
► The time that was most recently set flashes in the display
Select the preferred heating time using the Minus
(OFF, 1–12).
Press the On/Off button
guage settings (see Page 26). Press the On/Off button
► The standby indicator lamp
9.3. Setting the language
The following languages are available:
English, German, French, Italian, Dutch
The controller must be set to standby mode when this is programmed.
Press the On/Off
This takes you to the heating time menu. Press the Mode button
the language menu. Make your selection here using the Minus
buttons.
Confirm your selection using the Mode button
and Minus
4
5
to confirm your selection and go directly to the lan-
4
and Minus
4
5
lights up and remains lit.
8
buttons simultaneously for 3 seconds.
lights up.
8
buttons simultaneously for 3 seconds.
.
7
.
1
and Plus
5
6
to confirm.
4
7
and Plus
5
p. 26/38
buttons
to open
6