Important Information For Your Safety; Intended Use - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 78
Instructions for installation and use
p. 6/38

2. Important information for your safety

The wave.com4 11 kW sauna controller has been manufactured
according to the applicable safety regulations. However, hazards
may arise during use. You should therefore adhere to the following
safety information and the specific warnings in the installation and
operating instructions. Also observe the safety information for the
devices connected.

2.1. Intended use

The wave.com4 11 kW sauna controller is designed solely for oper-
ating and controlling the functions described in the technical data.
The sauna controller may only be used for operating and controlling
three heating circuits with a maximum output of 3.7 kW per heating
circuit.
When using the optional wave.com4 expansion board (WC4-H-PCB),
the maximum evaporator output is 3.0 kW.
Door monitoring is required For standardized remote control function
in accordance with EN 60335-2-53 a door monitoring is required.
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, severe injuries or death.
The warranty is void if the device is not used as intended.

Publicité

Table des Matières
loading

Table des Matières