Product Features - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Instructions for installation and use

3.4. Product features

The wave.com4 11 kW sauna controller features the following functions:
● Regulation of sauna heaters with a heating output of up to 11 kW.
● When an expansion board is installed, regulation of combined heaters with
a heating output of up to 11 kW and evaporator output of up to 3 kW.
● When a power booster is installed, the maximum power rating of 11 kW can
be increased.
● Option to connect external main switch
● Option to connect external light switch
● Switching and dimming a cabin light (up to 100 W bulb)
● Fan regulation (up to 100 W)
● Automatic heating time limit
The sauna controller shuts down automatically for safety reasons after the
maximum heating time (1 to 12 hours).
● Preset time function (1 to 24 hours)
● Acoustic signal for time interval (e.g: time to pour water on stones)
● Post-drying program
After operation in combined mode, the post-drying program starts automatically
to prevent mould or rot from forming in the sauna cabin. (3 setting options).
● Remote start function
● Eco mode
Eco mode ensures that the cabin temperature is the same after a break
(20, 40, 60 minutes).
● Overheat cut-out
The overheat cut-out is installed in the housing for the heater sensor. If a de-
fect causes the sauna heater to continue heating after reaching the preferred
temperature, the overheat cut-out switches the sauna heater off at a temper-
ature of around 139 °C.
p. 10/38