Important Information For Your Safety; Intended Use; Safety Information For The Installer - Sentiotec DC9 Instructions De Montage Et Mode D'emploi

Instructions for installation and use

2. Important information for your safety

The sauna control unit Finncontrol DC9 has been produced in ac-
cordance with the applicable safety regulations for technical units.
However, hazards may occur during use. You should therefore
adhere to the following safety information and the specific warning
notices in the individual chapters.

2.1. Intended use

The sauna control unit Finncontrol DC9 is used for operating and
controlling sauna heaters in a private household in accordance with
the technical data. It may only be used for operating and control-
ling 3 heating circuits with a maximum heating capacity of 3 kW
per heating circuit.
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, severe injuries or death.

2.2. Safety information for the installer

● Installation may only be performed by a qualified electrician or
similarly qualified person.
● Installing and connecting the sauna control unit may only be
performed when the power supply is disconnected.
● An all-pole disconnecting device with full cut-off must be fitted
on-site in accordance with overvoltage category III.
● The sauna control unit must be installed outside the sauna room
at a height of approx. 1.70 m or in accordance with the recom-
mendation issued by the sauna manufacturer. The ambient
temperature must be within a range spanning -10 °C to +40 °C.
● The heater sensor must be attached in a way that it is not af-
fected by inflow of air.
WORLD OF WELLNESS
p. 4/18