Fig. 26
5.4.12 Tools Page
From menu entry Tools it is possible to re-set the
predefined values for the entire configuration of
device or only for a number of specific sections.
This section:
• Update the firmware of the device.
• Restart the device.
Fig. 27
18
5.4.13 Video Analysis Page
The device can be configured to emit motion
detection alarms using ONVIF events.
This page allows you to define the following settings:
• Enable emission of motion detection events.
• Configure the algorithm sensitivity level.
Fig. 28
6 Accessories
A series of accessories for the device in use
is available. Refer to the HANDBOOK A for
relative descriptions.
7 Instructions for normal
operation
7.1 Enabling the wiper (Wiper)
Do not use the wiper if the outside
temperature is below 0°C or in case of ice.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (7.3 Special controls, page 19).
7.2 Enabling the washer (Washer)
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (7.3 Special controls, page 19).
MNVCMVXHDCAM_1813_EN