Instructions For Normal Operation; Enabling The Led Illuminator; Routine Maintenance - Videotec MAXIMUS MPX 2 Serie Manuel D'instructions

9 Instructions for normal
operation
Before carrying out any type of
maintenance, read the "Safety rules"
chapter carefully in the product manual.
Do not use the wiper if the ambient
temperature is under 0°C or if there is ice.
If it is left on, the wiper automatically
disables itself.
The device control can be performed through
different modes:
• Through the user's controls of the web interface (
8.2 Web interface, page 34).
• Through Video Management Software (VMS)
that supports the ONVIF protocol. In this case
the special controls are implemented using the
auxiliary commands of the ONVIF protocol.
• Through PTZ Assistant software (the PTZ Assistant
software is available to download on the product
web page of the website:
www.videotec.com).

9.1 Enabling the LED illuminator

MPXL is equipped with a LED illuminator. The
illuminator is composed of two groups of LEDs called
SPOT and WIDE. The operating parameters of the
illuminator are set using the web interface of the PTZ
unit.
MNVCMPXHDC_2222_EN
10 Maintenance
Before carrying out any type of
intervention, read the "Safety rules"
chapter carefully in the product manual.
When contacting VIDEOTEC for assistance please
provide the serial number and the identification
code of the model.
Use only VIDEOTEC original spare parts.

10.1 Routine maintenance

10.1.1 Inspecting the cables
The cables should not show signs of damage or
wear, which could generate hazardous situations. In
this case extraordinary maintenance is necessary.
10.1.2 Replacing the gasket
Replace the connection compartment cover seal
using the one supplied.
Open and close the connection compartment as
described in the previous chapters.
Replace the gasket, paying attention to position it
correctly.
Fig. 24
35