Autopan Enabling; Unit Reboot - Videotec ULISSE RADICAL THERMAL Manuel D'instructions

10.6 Autopan enabling

The Autopan function loads the 2 saved Presets in a
continuous manner.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (10.8 Special controls, page 54).
To deactivate this function, move the joystick or
restore a different type of movement.
Refer to the relative chapter for the configuration of
this function (8.1.8.7 Autopan Menu, page 31).
MNVCUPKT_1838_EN

10.7 Unit Reboot

Using the control device it is possible to reboot the
unit (for further information refer to the manual of
the control device in use).
For further information refer to the relative chapter (
10.8 Special controls, page 54).
53