Movement Parameters Page; Autopan Page - Videotec MAXIMUS MPXHD Manuel D'instructions

9.2.7 Movement Parameters page

From menu entry Movement Parameters it is possible
to control, via web, all Pan & Tilt parameters.
• Offset Pan: The pan & tilt has a mechanically
defined 0° position. The Offset Pan function allows
the definition of a different 0° position using
software.
• Fast Mode: It allows moving the Pan & Tilt at high
speed by moving the joystick to the end run.
• Economy Mode: It reduces the motor's torque
when the Pan & Tilt is at standstill to decrease
consumption. Do not enable in the presence of
strong wind or vibrations.
• Static Control: Enables control of the position only
when the pan & tilt is stopped
• Dynamic Control: Enables control of the position
only when the pan & tilt is moving
• Ceiling Mount: It rights the image and reverses
the handling controls.
• Autoflip: Turn the Pan & Tilt by 180° when the tilt
of the Pan & Tilt reaches the end run. It makes it
easier tracking subjects along corridors or roads.
• Maximum Speed: Sets the maximum manual
speed.
• Tilt Factor: Sets the reduction factor of the tilt axis
manual speed.
• Pan Limits: Enables the limits of Pan.
• Pan Start: Sets the start limit of Pan.
• Pan End: Sets the end limit of Pan.
MNVCMPXHD_1801_EN
• Tilt Limits: Enables the limits of Tilt.
• Tilt Start: Sets the start limit of Tilt.
• Tilt End: Sets the end limit of Tilt.
Fig. 42

9.2.7.1 Autopan Page

From menu entry Autopan it is possible to specify
the preset autopan start and end. Autopan is the
unit movement on the horizontal axis, between two
presets.
It is possible to set the speed with which the distance
is to be covered.
Fig. 43
31