Relocating The Support Surface - Stryker 2971 Isolibrium Manuel D'utilisation

Activating and resetting CPR (Continued)
Figure 1-7: CPR activation
To reset for CPR, pull down on red CPR strap

Relocating the support surface

Relocating the support surface is for the purpose of cleaning or moving to another InTouch bed frame.
WARNING
• Do not move the support surface without assistance.
• Do not use the support surface as a transfer device to avoid the risk of patient injury.
Prerequisite: Minimum of two operators are required to relocate the support surface and setup this product.
1. Make sure that there is not a patient on the support surface.
2. Remove the linens.
3. Unplug the power cord for the support surface from the foot end auxiliary power outlet.
4. Unplug the support surface connector.
5. Remove the headboard and footboard
6. Position an operator at each end of the support surface and remove the support surface and relocate.
Note: Use all four handles when relocating the support surface.
Note: See (Installation on page
7. Reinstall the InTouch headboard and footboard.
www.stryker.com
Operation
(Figure 1-8 on page
1-10) of the support surface.
2971-209-001 REV B
Figure 1-8: CPR reset
1-15). The support surface will begin to reinflate.
English
EN
1-15