Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
15. Plug the power cord for the support surface into the InTouch foot end auxiliary power outlet (A)
EN
page
1-12).
16. Make sure that the power cord is routed to the side of the bed and not out the foot end of the InTouch.
17. Plug in the InTouch power cord into a properly grounded hospital grade three-prong power outlet.
18. Calibrate the bed following the procedures in the InTouch maintenance manual.
Notes
•
Isolibrium is only operational when the power cord for the InTouch bed is in a 120v wall outlet.
•
When the support surface is plugged into the InTouch bed, the InTouch footboard will respond. See the InTouch
manual for more information.
1-12
Installation
Figure 1-2: InTouch foot end auxiliary power outlet and mattress connector
A
2971-209-001 REV B
(Figure 1-2 on
B
www.stryker.com
Publicité
Chapitres
Table des Matières
