Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Summary of safety precautions (Continued)
WARNING (CONTINUED)
•
Do not exceed the safe working load of the Isolibrium support surface. Excess weight could cause unpredictable
safety and performance of this system.
•
Always use extra caution when reading radiology images taken of a patient on a support surface because internal
components can cause artifacts and distort readings.
•
Always monitor the patient condition at regular intervals for patient safety.
•
Do not use the support surface as a transfer device to avoid the risk of patient injury.
•
Do not immerse the support surface or foot box in cleaning or disinfectant solutions.
•
Do not allow fluid to pool on the support surface. Fluids may cause degradation of components and may cause
unpredictable safety and performance of this product.
•
Always inspect the support surface covers (top and bottom) for tears, punctures, excessive wear, and misaligned
zippers as you clean the covers. If the cover is compromised, remove the support surface from service immediately
and replace the cover to prevent cross-contamination.
•
Always perform preventive maintenance based on the usage level of the product. An increase in usage which may
include more frequent cleaning and disinfection, may adversely affect the life of the support surface.
•
Always disinfect the support surface between patients, to avoid the risk of cross-contamination and infection.
•
Always make sure that you wipe each product with clean water and thoroughly dry each product after cleaning or
disinfecting. Some cleaning and disinfecting agents are corrosive in nature and may cause damage to the product if
you use them improperly. If you do not properly rinse and dry the product, a corrosive residue may be left on the
surface of the product that could cause premature degradation of critical components. Failure to follow these
cleaning or disinfecting instructions may void your warranty.
•
Always unplug the product power cord before cleaning or disinfecting to avoid the risk of shock.
•
Do not service or perform maintenance while the product is in use.
CAUTION
•
Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in
this manual.
•
Do not modify the product or any components of the product. Modifying the product can cause unpredictable
operation resulting in injury to patient or operator. Modifying the product also voids its warranty.
•
Do not allow sharp objects to come into contact with the support surface that could puncture, tear, or cut the cover.
•
Do not allow sharp edges from the X-ray plate to come in contact with the support surface cover. The
recommendation is you cover the X-ray plate with a pillow case or other device before placement under the patient.
If damaged, remove the support surface cover from service immediately to prevent cross contamination.
•
Do not iron, dry-clean, or tumble dry the support surface covers.
•
Do not power wash the support surface.
•
Always completely dry the support surface covers before storing, adding linens, or placing a patient on the surface.
•
Do not over expose the covers to higher concentration disinfectant solutions as these may degrade the covers.
•
Do not use accelerated hydrogen peroxides or quaternaries that contain glycol ethers as they may damage the
cover or the CPR strap print.
www.stryker.com
Warning/Caution/Note Definition
2971-209-001 REV B
English
EN
1-3
Publicité
Chapitres
Table des Matières
