Lifting The Inhibit In The Case Of An Error - SICK RE 4000 Notice D'instructions

Operating Instructions
RE 4000
8 010 416/08-10-03
Commissioning
4.4

Lifting the inhibit in the case of an error

The most frequent causes of the triggering of the inhibit state are:
 alignment errors between sensor and actuating element
 damage to the connecting cable between sensor and evaluation
unit
 insufficient approach speed (cf. chapter 1.4.3 "Minimum approach
speed and response range")
 failure to observe the delay time set
 Rectify error.
 Open protective device and close again.
 Perform test as described in chapter 4.1 "Tests before the first
commissioning".
© SICK AG • Industrial Safety Systems • Germany • All rights reserved
Chapter 4
73