Programming Help For Lokmaus 2 / R3 - Multimaus - Roco multiMAUS Manuel

The multiMAUS cannot be reset (3.5., page 52)
Scrolling in locomotive address mode is slow or
not possible at all
Programming Help for Lokmaus 2 / R3 – multiMAUS
Previous operating manuals for digital ROCO articles (e.g. 42624 turnout drive) only describe the standard pro-
gramming mode for Lokmaus 2 / R3. The following includes a table which compares the programming procedure
for the Lokmaus 2 / R3 and quick programming (see page 42) on the multiMAUS.
For more information see the operating manual for the Lokmaus 2 / R3. To program CV29 see the operating instruc-
tions included with the decoder.
CV
1 – Address
2 – Minimum speed
3 – Start-up delay
4 – Braking delay
5 – Maximum speed
29 – Decoder settings
Change speed steps
The ROCO electrics handbook, article number 82071, which is available as a CD-ROM from your local dealer,
includes many tips and much information on the subject of model railway electrics and digital technology.
The ROCOMOTION system controller also has numerous options which can also be used in conjunction with
the multiMAUS. For information on the ROCOMOTION consult your local dealer or visit www.roco.cc.
58
58
In this case, it helps to pull the plug and press the shift key
▪
together with the "MENU" key when plugging the cable
back in.
The multiMAUS is reset completely to the factory set-
▪
tings. Since this deletes the locomotive library, you
should make sure you are certain you wish to take this
step.
There is a problem with the X-Bus. Switch the system off
▪
and back on again. Check whether menu item 3.3.2. is set
to "automatic". It is possible that two devices have the
same X-Bus address.
multiMAUS
+
+
+
+
+
Can only be programmed in menu
mode (see page 49)
+
/
Lokmaus 2 / R3
(for comparison)
+
+
+
+
+
+
+
/