Operation With A Dcc Command Station; Pro; Programming Modes; Reading Cvs - Roco CV29 Manuel D'utilisation

Operation with a DCC Command Station ( multi MAUS/ multi MAUS

Programming modes:

The carriage reacts to all DCC programming types.
We recommend: direct CV programming (byte by byte) or POM mode (programming on main track).
The programming is described in the multi MAUS/multiMAUS
GB

Reading CVs:

With the appropriate equipment (e.g. Rocomotion 10785 or multiZENTRALE
value byte by byte and bit by bit.

Function key grouping for single operation

If you wish to operate the carriage separately, you can simply group the functions.
To do so, program the value 1 via CV61.
Experts can also "map" the functions individually (see Annex):
F-Key Function
F00 Carriage tail light
F01
Carriage doors corridor side
F02 Carriage doors
compartment side
F03 Interior carriage lighting
F04
Conductor's whistle
F05 Conductor's announcement
in german language

More functions

We are certain that you noticed when trying the set out that not all of the functions which are described in
the "function overview" are available in the delivery state.
So that more functions can be addressed with the Märklin
on the one hand: the "2
normal address.
Example 1
Address (CV1)=3 (default state)
2 address=4
nd
on the other: there is a dedicated function key mapping (refer to the table on the next page) which
addresses more functions at different addresses (1
activated via CV61 respectively.
20
8045868921.indd 20
Function Type
ON/OFF
OPEN/CLOSE
OPEN/CLOSE
ON/OFF
ON
ON/OFF
Operation with Märklin
address" . This is activated in the delivery state and is one higher than the
nd
manual.

pro

10832), you can read the
pro
Direction-
related

6021
1)
6021, you have
1)
address + 2 address), which can be
st nd
)
pro
Additional
sound




01.02.2010 13:51:38