Switching On Settings (Power On) - AOIP calys 60 IS Manuel D'instructions

Scroll down and select "Alarm"
Co n f i g u r a t i o n
Da t e / t i me
Re j e c t i o n [ 5 0 Hz ]
Ba u d r a t e [ 9 6 0 0 ]
OC Te s t
Al a r m
Pr e s s < > t o SET
Ge n e r a l
Us e r
Pr e s s < > t o SET
•
Select General and then Enable or Disable the general system alarms
NOTE: when you disable the alarms, at next turning on the selection will be
lose and alarms become active.
See par.10.1 about error messages.
•
Select User to set alarms definable by the user:
On Of f
Ch a n n e l
Mi n [ 0 ]
Ma x [ 1 0 0 ]
Pr e s s < > t o SET
•
Set the channel where to have threshold alarms with Channel
•
Set Min and Max threshold
NOTE: unit measure is referred to the used channel
•
Enable the alarm with "OnOff"
NOTE: in case of threshold overcoming, an acoustic signal is emitted until the
signal comes back return under threshold or the alarm is disabled.
Manuel d'intructions NTA47248-300A4
[ En a b l e ]
Al a r m
[ En a b l e ]
Us e r
[ o f f ]
[ c h 1 ]

5.15 Switching on settings (Power On)

It is possible to set how the instrument turns on through the "Power On" function
•
Press [MENU]
Pr e s s < > t o SET
Select "Configuration"
Di s p l a y
Po we r On [ Se t
Da t e / t i me
Re j e c t i o n [ 5 0 Hz ]
Ba u d r a t e [ 9 6 0 0 ]
Pr e s s < > t o SET
Select "Power On"
>
Pr e s s < > t o SET
•
Safe: Ch1 = voltage, Ch2 = off. This way avoids any risk of damage for the
instrument
•
Set Ch: it set the last channel settings
•
Set val: it set the last channel settings and the channel 2 output value
97
MENU
Co n f i g u r a t i o n
Un i t
Ra mp - Me mo r y s c a n
Da t a l o g g e r
Ad v a n c e d
Co n f i g u r a t i o n
Ch ]
Po we r On <
Sa f e
Se t Ch
Se t v a l