Applications; Calibrating A Temperature Indicator - AOIP calys 60 IS Manuel D'instructions

9 A
PPLICATIONS
9.1

Calibrating a temperature indicator

The following procedures will be used to test and calibrate temperature indicators.
•
Switch the calibrator ON
•
Connect the instruments as in figure.
•
Set the CH2 in output mode and configure it for the desired TC or RTD type
(e.g. TC type K).
To configure the channel, proceed as follows:
Press the [SELECT] key until "Select Ch2" is shown.
Ou t Ou t
SEL ECT Ch 2 SEL ECT Ch 2
Th e r mo c o u p l e Th e r mo c o u p l e
Ou t Ou t Rj i Rj i
RTD t h e r mo me t e r RTD t h e r mo me t e r
I n I n Rj e Rj e
Cu r r e n t Cu r r e n t
Of f Of f Rj r Rj r
Vo l t a g e Vo l t a g e
Re s i s t a n c e Re s i s t a n c e
Pr e s s < > t o SET Pr e s s < > t o SET Pr e s s < > t o SET Pr e s s < > t o SET
Pr e s s < > t o SET Pr e s s < > t o SET
Manuel d'intructions NTA47248-300A4
100.00 °C
15. 2000 15. 2000
Ch 1 Ch 1
Ch2 Ou t Tc K Rj i Ch2 Ou t Tc K Rj i
Rj i Rj i 10 0 10 0
Th e r mo c o u p l e Th e r mo c o u p l e
Tc K Tc K
Tc J Tc J
Tc T Tc T
Tc R Tc R
Tc S Tc S
Pr e s s < > t o SET Pr e s s < > t o SET
Change the output value by using the 6 [
mode to insert the value).
mA mA
° C ° C
02 02
. .
104
] keys (You can also use the calculator