Operations; Data Hold; Zeroing Measure; Storing - AOIP calys 60 IS Manuel D'instructions

5 O
PERATIONS
The operating mode (i.e., Source, measure) is shown on the display. Channel 1 can
only measure electrical parameters; Channel 2 can Sourcing or Measuring (XP
model only) electrical parameter. If internal or external pressure sensors are
installed, an additional Pressure channel can be set.
When you turn the calibrator ON, it powers up with the last configuration.
Please refer to Chapter 2.4 for electrical connections.
5.1

Data Hold

Press the [HOLD/ZERO] key to freeze the measure. The symbol "H" is displayed in
the status box.
Press the [HOLD/ZERO] key to release the measure. The symbol "H" is removed
from the status box.
5.2

Zeroing measure

To zero a measure on one of the 2 channels, you have to press [HOLD/ZERO] key
until the numeric pad symbol appears in status box. Now you have to press one
of the numeric keys towards up way [ ] to zero a measure of the channel in the
upper part of the display. Otherwise, press [ ] to zero a measure of the channel in
the lower part of the display. Consequently, "Z" appears on the related channel (see
par.2.2); to vanish this symbol, the only way is to restart the instrument.
Z c h 1
c h 2 Ou t
1 0 0 . 0 2
Manuel d'intructions NTA47248-300A4
0 . 0 0 0 0
mA
Tc K Rj i °C
5.3

Storing

Calys60/80/120 can store up to 10 configurations with related measures.
•
Press [RCL/STO] until "Sto" and
•
Press a number corresponding to the desired memory position
After memorization of a setup and measure values, those symbols in the status box
disappear.
To recall one of the memories:
•
Press for a short time [RCL/STO], "Rcl" and
•
Press a number corresponding to the desired memory position
After recalling a memory, the measure is in hold function (hence, "H" appears).
5.4 Calculator
Calys60/80/120 implement a calculator function that allows performing simple
mathematical operations or transferring a value to output channel.
•
Press [CALC], the calculator box and the related symbol appear
0 . 0 0 0 0 0 0
•
Insert the first value of the operation by means of numeric pad, select the
operation by pressing [CALC] (+, -, *, /), insert the second value of the
operation, press [=] to show the result
NOTE: to insert decimal digits, press [SELECT] to act on decimal digits. By
pressing [IN], the value of in channel is copied in the calculator; by
pressing [OUT], the calculator value is sent to the output channel.
Example: 23 x 4.5
78
appear in the status box
appear in the status box
0 . 0 0 0 0
1 0 0 . 0 2