Pressure; Pressure Unit Setting - AOIP calys 60 IS Manuel D'instructions

−
XScale: allows to perform a linear or square scaling for your input
parameter (e.g. For transforming a 4/20 mA input to a –1 to 2 bar reading
on the display)
•
Press the [ ] key to select the option. Press the [ESC] key to return in
measure mode without changes.
If you have select "XScale" option, the display will show:
X1
X2
X3
X4
Se t
Pr e s s < > t o SET
•
Press the [ ] and [ ] keys to choose the Xscale function.
•
Press the [ ] key to confirm the selection and go to measuring mode. Press
the [ESC] key to return in measure mode without changes.
(for Xscale function, see par.4.3)
If you have select "LinMan" option, the display will show the list of all sensor
linearizations you have created.
My Se n s o r 1
My Se n s o r 2
My Se n s o r 3
My Se n s o r 4
My Se n s o r 5
Pr e s s < > t o SET
•
Press the [ ] and [ ] keys to choose the sensor name.
•
Press the [ ] key to confirm the selection and go to measuring mode. Press
the [ESC] key to return in measure mode without changes.
5.4.9

Pressure

•
Press the [SELECT] key until "SELECT Pressure" is shown.
Manuel d'intructions NTA47248-300A4
Xs c a l e
X1
L i n Ma n
Pr e s s < > t o SET
•
Press the [ ] and [ ] keys to highlight the sensor to be displayed.
•
Press the [ ] key to confirm the selection and going in measuring mode.
Press the [ESC] key to return in measure mode without changes.
5.4.10

Pressure Unit Setting

•
Press the [MENU] key. The following page is shown:
Pr e s s < > t o SET
85
SEL ECT Pr e s s u r e
Pl
Ph
Ph - Pl
Ph +Pl
Pe
MENU
Co n f i g u r a t i o n
Un i t
Ra mp - Me mo r y s c a n
Da t a l o g g e r
Ad v a n c e d