Pressure Zeroing; Resistance - AOIP calys 60 IS Manuel D'instructions

Select the "Unit" option.
Te mp e r a t u r e
Pr e s s u r e [ mb a r ]
Xs c a l e
Pr e s s < > t o SET
Select the "Pressure" option.
Pr e s s u r e
mb a r
b a r
Pa
h Pa
k Pa
Pr e s s < > t o SET
•
Press the [ ] and [ ] keys to highlight the engineering unit you would like to
use in pressure sourcing and measuring.
•
Press the [ ] key to confirm the selection and going in measuring mode.
Press the [ESC] key to return in measure mode without changes.
5.4.11

Pressure Zeroing

•
To zeroing the pressure channel, hold down the [HOLD/ZERO] key for
4 seconds while in pressure display mode. The symbol
status box. Press the [ ], [ ] key if you need to zero the upper or the lower
display.
Manuel d'intructions NTA47248-300A4
Un i t
is displayed in the
5.4.12

Resistance

•
Press the [SELECT] key until "SELECT CH1" or "SELECT CH2" is shown.
If you choose the Channel 1 setting the calibrator will display:
Pr e s s < > t o SET
If you choose the Channel 2 setting the calibrator will display:
N.B. Channel 2 can measure only on Calys 120 IS model.
Pr e s s < > t o SET
•
Press the [ ] and [ ] keys to highlight the "In" parameter.
•
Press the [ ] key to select the option. Press the [ESC] key to return in
measure mode without changes.
Pr e s s < > t o SET
•
Press the [ ] and [ ] keys to highlight the "Resistance" parameter.
•
Press the [ ] key to select the option. Press the [ESC] key to return in
measure mode without changes.
86
SEL ECT Ch 1
Th e r mo c o u p l e
RTD t h e r mo me t e r
Cu r r e n t
Vo l t a g e
Re s i s t a n c e
SEL ECT Ch 2
Ou t
I n
Of f
I n
Th e r mo c o u p l e
RTD t h e r mo me t e r
Cu r r e n t
Vo l t a g e
Re s i s t a n c e