Rs232 - Usb Adaptor Installation Setup; Installing Driver For The Rs232/Usb Adaptor - AOIP calys 60 IS Manuel D'instructions

7 RS232 – USB ADAPTOR INSTALLATION SETUP
The RS232/USB adaptor can be used to directly connect the instrument to a
computer without the RS232 serial port, but with the USB port only. The adaptor can
be used with PCs under the operating systems Windows™XP and Windows™ 95/98.
Depending on the configuration of the computer, the adaptor could be automatically
identified or not. If the adaptor isn't properly identified you'll need to manually install
its driver, that you can find on the instrument's software CD.
You need to follow the driver installation below only at first connection of the adaptor.
Then, every time you connect the adaptor to your USB port, it will be automatically
identified and it will be ready to operate.
•
If you have previously installed a similar adaptor on your pc and the drivers
that are about to install are different from those already installed, please
uninstall the already installed drivers FIRST. Please refer to the Driver's
Uninstall procedure of your Operating System.
7.1

Installing driver for the RS232/USB adaptor

•
Close all the active windows and/or applications.
•
If you computer runs in Windows™XP or Windows™ XP SP1, temporally
disconnect the PC from the web. To do this, temporally remove the network
cable from your pc, if connected, or by disabling your network card going to
the "Control Panel \ Network and Dial-Up Connections", right-clicking on the
appropriate connection and selecting "Disable" from the menu. The
connection can be re-enabled after the correct driver installation. This it's not
necessary if your computer runs Window™ XP SP2 if configured to ask
before connecting to Windows Update. Windows™ XP SP2 can have this
parameter already setted, and to verify this open the Control Panel, select
"System", select the Hardware tab and click "Windows Update". Please verify
that this option is DISABLED.
•
Connect the adaptor to a USB port of your computer. This will automatically
launch the "Windows Found New Hardware Wizard", if the adaptor is not
automatically identified and installed on your system.
•
The following page will be displayed:
Manuel d'intructions NTA47248-300A4
•
select "No, not this time" to avoid the driver search in internet, then click
"Next" to proceed with the installation
•
Select the second option: "Install from a list or a specific location (Advanced)",
then click "Next"
100