Evolution RAGE 6 Manuel D'instructions page 25

www.evolutionpowertools.com
MAINTENANCE
WARNING:
Ensure that the machine is disconnected from
the mains supply before any maintenance tasks or adjustments
are attempted.
Cleaning
After each use the machine should be cleaned. Remove all
sawdust etc from the visible parts of the machine with a
vacuum cleaner. A vacuum cleaner can also be connected to
the machine dust extraction port at the rear of the machine.
This should remove debris from the inside of the machine.
Never use solvents to clean plastic parts, as solvents can
damage them. Clean only with a soft damp cloth.
Riving Knife
The riving knife is a very important component and comes
factory fitted and correctly aligned and adjusted. The riving
knife prevents the work from binding as it passes through the
blade. Inspect the riving knife at regular intervals and replace it
if it is worn or damaged.
Note: Use only a genuine Evolution Riving Knife, as this is a
dedicated component for this machine. Non genuine parts
could be dangerous. If in any doubt, please contact the
Helpline.
Push Stick
A plastic push stick is provided with the machine. When not in
use store the push stick on the machine.
Note: If the push stick becomes damaged it should be replaced.
If the operator makes their own push stick, we recommend that
it follows the same pattern as that supplied.
Replacement push sticks are available from Evolution
Power Tools.
25
EN
FR
IT
NL