Evolution RAGE 6 Manuel D'instructions page 10

8) Always make sure that your extension
cord is in good condition. When using an
extension cord be sure to use one that is heavy
enough to carry the current that your tool will
draw. An undersized cord will cause a drop
in line voltage, resulting in loss of power and
overheating.
9) Do not use the tool while tired or under
the influence of drugs, alcohol or any
medication. Following this rule will reduce
the risk of electric shock, fire or serious
personal injury.
10) Save these instructions. Refer to
them frequently and use them to instruct
others who may use this tool. If someone
borrows this tool, make sure they have these
instructions also.
11) When the correct blade to cut the
material has been fitted, this saw is
recommended for cutting steel and
ferrous metals, aluminium and non-
ferrous metals, wood, and plastic only.
12) Do not use saw blades with High Speed
Steel (HSS) or blades that are damaged or
deformed.
13) Replace the table insert when worn.
14) Use only saw blades recommended
by the manufacturer and which are the
exact bore and diameter required for this
machine.
15) Connect your mitre saw to a dust
collecting device (I.D.Ø32mm) when
sawing material likely to cause dust.
16) Select saw blades in relation to
the material to be cut. Use only genuine
Evolution or Evolution recommended
accessories.
17) Check the maximum depth of cut.
18) When sawing long work pieces, always
use extra support to provide better
support, and use clamps or other clamping
devices. To reduce the risk of injury, return
www.evolutionpowertools.com
the slide carriage to the full rear position after
each crosscut operation.
19) The operator is adequately trained
in the use adjustment and operation and
operation of the machine.
20) Provide for adequate room lighting at
your workplace or for adequate lighting of
the immediate work area.
21) When fitted with a laser no exchange
with a different type of laser is
permissible. Repairs shall only be carried out
by the laser manufacturer or an authorised
agent.
22) Refrain from removing any cut-offs
or other parts of the workpiece from
the cutting area whilst the machine is
running and the saw head is not in the
rest position. Never reach around the saw
blade. Turn off tool and wait for saw blade to
stop before moving workpiece or changing
settings.
23) Never stand on this tool. Serious injuries
could occur if this tool tips over and you come
into contact with the saw blade.
24) Reduce the risk of unintentional
starting. Make sure switch is in off position
before plugging in.
WARNING:
The operation of any mitre saw
can result in foreign objects being thrown
into your eyes, which can result in severe
eye damage. Before beginning power tool
operation, always wear safety goggles or
safety glasses with side shield and a full face
shield when needed.
WARNING:
If any parts are missing, do not
operate your mitre saw until the missing parts
are replaced. Failure to follow this rule could
result in serious personal injury.
10