Evolution RAGE 6 Manuel D'instructions page 19

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

www.evolutionpowertools.com
OPERATION
3. Body and Hand Position
Never place hands near the cutting area and keep hands
away from the path of the blade.
Hold the workpiece firmly to the fence to prevent
movement. Use a clamp if necessary but check that it is
positioned so that it does not foul the blade.
Before making a cut. Make a dry run with the power off so
you can see the path of the blade.
Keep hands in position until the ON/OFF trigger has been
released and the blade has completely stopped.
4. On/Off Switch Operation
The On/Off switch is located in the cutting handle (Fig. 9) and
incorporates several safety features to guard against accidental
actuation.
To switch 'On'
Grasp the saw handle.
Slide the trigger switch safety locking slide downwards.
Press the trigger switch. The machine will start.To release the
lower safety guard and cutting head, press the head release
thumb button on the top of the saw handle. (Fig. 10)
Gently lower the cutting head through the workpiece to
make a cut.
To switch 'Off'
Allow the cutiing head to rise to its upper position.
Release the trigger switch, thumb button and safety locking
slide.
Wait for the saw blade to completely stop before removing
your hand from the cutting handle.
The safety locking slide and head release button will
automatically deploy to 'safety mode' .
5. Chop Cutting
The saw handle is gently pushed down to cut through a
workpiece.
Place the workpiece on the table and against the fence in the
desired position. Secure with clamps if necessary.
Grasp the saw handle.
Turn on the saw using the trigger switch and allow the blade
to reach full operating speed.
Press the cutting head release button to release the saw
head.
Gently push the saw head down and cut through the
workpiece.
After the cut is completed, turn off the saw by releasing the
trigger switch, and allow the blade to come to a complete
halt before removing your hands or the workpiece from the
machine.
FIG. 9
FIG. 10
19
EN
FR
IT
NL

Publicité

Chapitres

Table des Matières
loading

Table des Matières