Evolution RAGE 6 Manuel D'instructions page 17

www.evolutionpowertools.com
OPERATION
3. Debris collection bag (Optional Accessory)
The Debris Collection Bag should be attached at the debris
extraction port.
•
Slide the frame of the collection bag on to the outlet of the
extraction port, ensuring that it is firmly connected.
•
To release the bag, slide the frame in the opposite direction.
Note: To ensure optimal dust collection, empty the dust bag
when it becomes approximately 60% full.
WARNING:
Before cutting metal materials, the collection bag
should be removed and replaced with a blanking plug
(not supplied).
Reinstate the dust bag when cutting wood.
4. Fitting the Hold Down Clamp (Fig. 7)
Two sockets (one either side) are incorporated into the rear of
the machines fence.
•
Fit the clamp to the retaining socket that best suits the
cutting application, ensuring that it is fully pushed down.
•
Tighten the fence thumbscrew to lock the pillar into the
socket.
•
Put the workpiece to be cut onto the saw rotary table.
•
Adjust the clamp using the thumbscrew and hand-wheel so
that it securely holds the workpiece to the saw table. Ensure
that the clamp does not foul the blade or any other moving
machine parts. FIG. 7
17
EN
FR
IT
NL