TOHATSU BFT 60A Manuel D'utilisateur page 132

7. Then using a torque wrench,
tighten the castle nut until the first
available groove in the castle nut
aligns with the cotter pin hole. Do
not tighten past the first alignment
of the castle nut groove and the
cotter pin hole.
TIGHTENING TORQUE LIMIT:
BFT60A model
34 N·m (3.5 kgf·m, 25 lbf·ft),
BFW60A model
44 N·m (4.5 kgf·m, 33 lbf·ft)
Do not tighten the castle nut above
the TIGHTENING TORQUE
LIMIT or the propeller and shaft
may be damaged.
8. Be sure to replace the cotter pin
with a new one.
• Use a TOHATSU Genuine
stainless steel cotter pin or
equivalent cotter pin and bend
the pin ends as shown the
previous page.
Note that these wrenches are not
included with the tool set that comes
with the outboard motor. Contact
your authorized TOHATSU outboard
motor dealer for additional tool
information.
MAINTENANCE
129