Fuel Filter/Water Separator - TOHATSU BFT 60A Manuel D'utilisateur

Masquer les pouces Voir aussi pour BFT 60A:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fuel Filter/Water Separator

The fuel filter (inside the strainer cup)
is located under the engine cover near
the engine cover latch on the boat
side.
Water or sediment accumulation in
the filter can cause loss of power or
hard starting. To prevent engine
malfunction, check and replace the
fuel filter periodically.
A red ring float is located inside the
strainer cup. It floats on top of the
water and indicates how much water
has accumulated in the strainer cup.
Inspection interval:
Every 100 operating hours or 6
months.
Replacement interval:
Every 400 operating hours or 2 years
Gasoline is extremely flammable,
and gasoline vapor can explode,
causing serious injury or death. Do
not smoke or allow flames or
sparks in your working area.
KEEP OUT OF REACH OF
CHILDREN.
• Always work in a well-ventilated
area.
• Be sure that any fuel drained
from the outboard motor is
stored in a safe container.
• Be careful not to spill fuel when
replacing the filter.
Spilled fuel or fuel vapor may
ignite. If any fuel is spilled, make
sure the area is dry before
starting the engine.
MAINTENANCE
<Inspection>
FUEL TUBE ASSEMBLY
CONNECTOR
1. Disconnect the fuel tube assembly
connector from the fuel tank (see
page 104).
2. Remove the engine cover (see page
53).
121

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Bfw 60a

Table des Matières