Cooling Water Intake Port; Indicator Light - TOHATSU BFT 60A Manuel D'utilisateur

COOLING WATER CHECK HOLE

COOLING WATER INTAKE PORT

(each side)
5. After starting, check whether the
cooling water is flowing out of the
cooling water check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.
If water does not flow out, or if
steam comes out, stop the engine.
Check to see if the screen in the
cooling water intake port is
obstructed and remove foreign
materials if necessary. Check the
cooling water check hole for
clogging. If water still does not flow
out, have your outboard motor
checked by an authorized
TOHATSU outboard motor dealer.
Do not operate the engine until the
problem has been corrected.
6. Check to see if the oil pressure
indicator turns ON.
If it does not turn on, stop the engine
and perform the following
inspections.
1)Check the oil level (see page 54).
2)If the oil level is normal and the oil
pressure indicator light does not
turn ON, consult with an
authorized TOHATSU outboard
motor dealer.
STARTING THE ENGINE
ENGINE OIL PRESSURE

INDICATOR LIGHT

NORMAL: ON
ABNORMAL: OFF
71