Radio Code Programming (Code Button) - Erreka NAOS Manuel De L'installateur

4

RADIO CODE PROGRAMMING (CODE BUTTON)


Before programming the radio code, ensure the
operator is programmed for the type of transmitter
to be used: Fixed Code (F), Standard Roller Code (r)
or Personalised Roller Code (rÿ ) . This is done in
programming Step 6.
Programming the Fixed (F), Standard (r) or Personalised roller (rÿ ) codes
1 With the display showing CL,
press CODE for at least 2
seconds.

F, r or rÿ lights up, depending
on the type of transmitter to
be programmed, indicating
that the operator is ready to
memorise the code.
Completely deleting the memory
1 With the display showing CL,
press CODE for at least 2
seconds.

F, r or rÿ lights up, depending
on the type of transmitter to
be programmed, indicating
that the operator is ready to
memorise the code.

The memory can store up to 20 different codes.
To completely delete the memory, press CODE
for 5 seconds. All the codes will be deleted (it is not
possible to delete just some of them). The process is
explained below.
2 Release CODE and press the
button of the transmitter to be
programmed once.

The display flashes and the
operator buzzes to confirm
programming.
2 Keep code pressed for at least 5
seconds.

The screen will go off,
indicating that the codes
have been deleted.
STARTING UP AND PROGRAMMING
3 The display will show CL again
after 2 seconds, leaving the
operator ready to run.
3 The display will show CL again
after 2 seconds, leaving the
operator ready to run.
NAOS garage door opener operator
H278A
H278B
61