Start Up And Programming; Connection To The Mains; Display - Erreka DINGO Manuel De L'installateur

START UP AND PROGRAMMING

1

CONNECTION TO THE MAINS

1 Connect the operator to the power supply.
2 Press the ENTER button: the display should light up

Reset (rS): after connecting the electricity power
supply and activating any of the key devices, the
gate closes to the stopper, with the stopper being
assigned the position "gate closed".
2

DISPLAY

Esc
D1: Display Menus
D2: Display Parameters
D3 - D4: Display Parameter value

The display goes off following a long period
without pressing any key on the control
board. Press the ENTER key to reactivate.
54
Installation Guide

Indications during operation:
D1 and D2:
CL
CL
OP
OP
PC
PO
PO
Enter
XX
StOP
PA
rS
D3 and D4:
C4
C5
E1
F1
bA
Ftço
M259C
Indications during programming
D1 (Menus): Shows the selected menu. The following
menus are available:
C
P
F
A
ç
D2 (Parameters):
Shows each parameter of the selected D1 menu.
D3 - D4 (Parameter Values):
Shows the value or option of the selected D2
parameter.
During programming, ensure there is no
person or object in the radius of action of the
gate and the operation mechanisms.
(static) Gate closed
(flashing) Gate closing
(static) Gate open
(flashing) Gate opening
(flashing) Pedestrian door closing
(static) Pedestrian door open
(flashing) Pedestrian door opening
(countdown) Gate on standby
Operator unlocked
(static) Pause (operation not complete)
(static) Gate searching for close position
Opening safety device activated
Closing safety device activated
Encoder motor shutdown
Force limit exceeded
Battery working
Photocells defective (testing)
Prior Conditions menu
Programming menu
Main Functions menu
Advanced Functions menu
Operation Counter