Erreka NAOS Manuel De L'installateur page 52

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 69
INSTALLATION
Fitting the central support
1
6
7
Positioning the opening stopper
48
Installation guide
A
3
6
A
C
8
B
5
11
1 Position the central support (6) in the guide-track
(3). It should be in the middle of the track, at the
same distance (X) from the front (1) and rear (8)
supports.
2 Fold the tabs (A) to secure the support to the guide-
track.
3 Attach the support (6) to the ceiling strip (7) with the
two screws and two nuts (B) and (C).
P278F
1 Open the door completely and install the opening
stopper (11), so the stopper (11) is supported
against the carriage (5) with the door open.
Use two self-drilling, self-tapping screws.
O
IT IS ESSENTIAL TO INSTALL THE OPENING
STOPPER (11) CORRECTLY, since the carriage
must be slightly touching this stopper (11)
when programming opening and closing. If this
is not the case, the operation will not be
programmed correctly.
P278M

Publicité

Table des Matières
loading

Table des Matières