Erreka NAOS Manuel De L'installateur page 61

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 69
Step 6 (menu 6): Fixed Code transmitters or Roller Code transmitters
Personalisation for Roller Code transmitters with personalised code
To
use
Roller
personalised code, select the option r and
activate the seed (electric bridge or button, as
appropriate) of a personalised transmitter while
digit r is flashing. The display will show rÿ .
M278P6
Code
transmitters
with
STARTING UP AND PROGRAMMING
1 With the display showing 6, press SET once: digit F
will start flashing on the display (this is the preset
value for this parameter).
2 Pressing the |+ and |- buttons, select the type of
transmitters to use:
F: Fixed Code transmitters
r: Roller Code transmitters
3 Once the required value is selected, press SET to
confirm and save it.
4 Press the |+ button once to access the next
programming step.
In steps 4 to 12 (menu 4 to 12), programming can
be finished in advance by holding down SET (until
CL is displayed), without having to continue
advancing using the |+ button.
• The receiver memory must be empty in order to
subsequently change from r to F or from rÿ to r,
to which end all codes must be deleted as shown
in "Radio code programming (CODE button)" on
page 61.
NAOS garage door opener operator
M278P6r
57

Publicité

Table des Matières
loading

Table des Matières