Radio Code Programming (For Rsd Only) - Erreka TORO Manuel De L'installateur

3

RADIO CODE PROGRAMMING (FOR RSD ONLY)


When using the ERREKA RSD plug-in receiver (decoder-free receiver, trinary code, 433Mhz), the radio code can
be recorded in the control board itself, as explained below. In other cases, follow the instructions of the plug-in
receiver used.

The programming of the radio in total and pedestrian opening are independent. Different transmitters can be
used with different codes.
Total opening code programming
Pedestrian opening code programming
PROGRAMMING AND STARTUP KM1800
1 Connect the control panel power supply (SW1 in
ON).
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP4 in "ON"; DIP2, DIP3, DIP5 and
DIP6 in "OFF".

DL3 lights up.
4 Select the required code in the transmitter.
5 Press the channel to be used for total opening.

If programming has been carried out correctly,
DL2 flashes.
6 Place DIP1 and DIP4 in "OFF" (DL2 and DL3 will go
G121R2
off).
7 Disconnect and reconnect the panel power supply.
1 Connect the control panel power supply (SW1 in
ON).
2 Close the leaf of the gate by pressing PUL1.
3 Place DIP1 and DIP6 in "ON"; DIP2, DIP3, DIP4 and
DIP5 in "OFF".

DL3 lights up.
4 Select the required code in the transmitter.
5 Press the channel to be used for pedestrian opening.

If programming has been carried out correctly,
DL2 flashes.
6 Place DIP1 and DIP6 in "OFF" (DL2 and DL3 will go
G121S2
off).
7 Disconnect and reconnect the panel power supply.
TORO operator for sliding gates
71