Erreka NAOS Manuel De L'installateur page 62

STARTING UP AND PROGRAMMING
Step 7 (menu 7): step-by-step or automatic closing and standby time
Step 8 (menu 8): slowdown distance in closing
58
Installation guide
1 With the display showing 7, press SET once: digit 00
will start flashing on the display (this is the preset
value for this parameter).
2 Pressing the |+ and |- buttons, select closing mode
and standby time in automatic mode:
00: step-by-step
01: automatic, 1 second standby
...
30: automatic, 30 seconds standby
1ÿ 0 : automatic, 1 minute standby
1ÿ 1 : automatic, 1 minute and 10 seconds standby
...
4ÿ 0 : automatic, 4 minutes standby
M278P7
3 Once the required value is selected, press SET to
confirm and save it.
4 Press the |+ button once to access the next
programming step.

In steps 4 to 12 (menu 4 to 12), programming can
be finished in advance by holding down SET (until
CL is displayed), without having to continue
advancing using the |+ button.
1 With the display showing 8, press SET once: digit 1
will start flashing on the display (this is the preset
value for this parameter).
2 Pressing the |+ and |- buttons, select the slowdown
distance in closing (measured in the guide-track):
1: 50 mm
2: 100 mm
3: 250 mm
4: 500 mm
3 Once the required value is selected, press SET to
confirm and save it.
4 Press the |+ button once to access the next
M278P8
programming step.

In steps 4 to 12 (menu 4 to 12), programming can
be finished in advance by holding down SET (until
CL is displayed), without having to continue
advancing using the |+ button.