Step 2 (menu 2): door closed position (closing stopper)
Step 3 (menu 3): self-learning opening and closing forces
1 With the display showing 3, press SET once: the
door will open and number 3 will start flashing on
the display.
2 When the door has stopped, press SET to confirm.
Number 3 will be static on the display.
3 Press SET once again for the door to start closing.
1 With the display showing 2, press SET once: number
2 will start flashing on the display.
2 Close the door to the closing stopper by pressing the
|- button. Adjust position using the |+ and |-
buttons.
3 Press SET to programme door closed position.
Number 2 will stop flashing on the display,
indicating that it has been programmed.
4 Press the |+ button once to access the next
programming step.
M278P2
4 When the door has finished closing, press SET to
confirm. Number 3 will stop flashing on the display,
indicating that the opening and closing forces have
been programmed.
5 Press the |+ button once to access the next
programming step.
STARTING UP AND PROGRAMMING
NAOS garage door opener operator
M278P3
55