Erreka NAOS Manuel De L'installateur page 48

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 69
INSTALLATION
Procedure
Assembling the guide-track
C
D
44
Installation guide
A
B
P278N
E
F
G
P278P
The complete guide-track assembly instructions are
attached with the guide-track, which is supplied
separately. These instructions are summarised
below.
1 Introduce each guide-track section in the overlap
area (A) of the next section, until both guide-track
sections come into contact with each other.
2 Fit the front support (B).
3 Move the pulley unit (C) to the front end of the
guide-track and assemble the rod, spring, bushing,
washer and nut (D), checking that the chain (E) is
correctly placed on the pulley and pinion.
4 Tighten the chain by turning the nut (F) as far as it
goes, and then loosen it slightly until the bushing (G)
can be turned by hand.

Publicité

Table des Matières
loading

Table des Matières