Setting Parameters (Set Button) - Erreka NAOS Manuel De L'installateur

STARTING UP AND PROGRAMMING
3

SETTING PARAMETERS (SET BUTTON)


Programming is only accessible with the door
stopped. It is not accessible with the door opening,
closing or timed to close.

During programming, the operator does not start
any operation.
Step 1 (menu 1): door open position (opening stopper)
54
Installation guide
In general, the programming procedure is as follows:
1 To enter programming mode, hold down the SET
button until
programming menu number 1 (step 1).
2 Use the |+ and |- buttons to scroll through the
different menus to the one to be modified.
3 Once the required menu is reached, press the SET
button to access the different menu options.
4 In most menus the |+ and |- buttons select the
required option for this menu. Press SET to confirm
once selected, returning to the main menu.
5 As of menu number 4 (step 4), programming can be
finished in advance by holding SET down until
CLappears, without the need to continue advancing
using the |+ button.
6 The display will show CL at the end of
programming.
Each menu is explained in detail below.
M278P0
1 With the display showing rS, enter programming
mode by holding SET down until 1 appears,
indicating programming menu number 1 (step 1).
2 Press SET once: number 1 will start flashing on the
display.
3 Open the door to the opening stopper by pressing
the |+ button. Adjust position using the |+ and |-
buttons.

When programming door open position, IT IS
ESSENTIAL TO OPEN THE DOOR UNTIL THE
CARRIAGE IS SLIGHTLY TOUCHING THE TRACK-
GUIDE'S OPENING STOPPER. If this is not the
case, the operation would not be programmed
correctly.
4 Press SET to programme door open position.
Number 1 will stop flashing on the display,
indicating that it has been programmed.
5 Press the |+ button once to access the next
programming step.
M278P1
1
digit appears, indicating