Personnel Qualifications; Danger In The Event Of Non-Observance Of The Safety Instructions; Safety Consciousness On The Job; Safety Instructions For The Operator - salmson IXENS Manuel D'installation Et Mise En Service

English
2.2

Personnel qualifications

2.3 Danger in the event of non-
observance of the safety
instructions
2.4

Safety consciousness on the job

2.5

Safety instructions for the operator

2.6 Safety instructions for installation
and maintenance work
70
• Rating plate
• Warning sticker
must be strictly complied with and kept in legible condition.
The installation, operating and maintenance personnel must have the
appropriate qualifications for this work. Area of responsibility, terms
of reference and monitoring of the personnel are to be ensured by the
operator. If the personnel are not in possession of the necessary
knowledge, they are to be trained and instructed. This can be accom-
plished if necessary by the manufacturer of the product at the request
of the operator.
Non-observance of the safety instructions can result in risk of injury
to persons and damage to the environment and the product/unit.
Non-observance of the safety instructions results in the loss of any
claims to damages.
In detail, non-observance can, for example, result in the following risks:
• Danger to persons due to electrical, mechanical and bacteriological
factors
• Damage to the environment due to leakage of hazardous materials
• Property damage
• Failure of important product/unit functions
• Failure of required maintenance and repair procedures
The safety instructions included in these installation and operating
instructions, the existing national regulations for accident prevention
together with any internal working, operating and safety regulations
of the operator are to be complied with.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
• If hot or cold components on the product/the unit lead to hazards,
measures must be taken onsite to guard them against touching.
• Guards protecting against touching moving components (such as the
coupling) must not be removed whilst the product is in operation.
• Leakages (e.g. from a shaft seal) of hazardous fluids (e.g. explosive,
toxic or hot) must be conveyed away so that no danger to persons or
to the environment arises. National statutory provisions are to be
complied with.
• Highly flammable materials are always to be kept at a safe distance
from the product.
• Danger from electrical current must be eliminated. Local directives or
general directives [e.g. IEC, VDE etc.] and instructions from local
energy supply companies must be adhered to.
The operator must ensure that all installation and maintenance work is
carried out by authorised and qualified personnel who are sufficiently
informed from their own detailed study of the operating instructions.
Work on the product/unit may only be carried out when the system is
at a standstill. It is mandatory that the procedure described in the
installation and operating instructions for shutting down the product/
unit be complied with.
Immediately on conclusion of the work, all safety and protective
devices must be put back in position and/or recommissioned.
Salmson 01/2017