Memorising The Keygo Io Remote Controls; Memorising 3-Button Remote Controls; Clearing The Remote Controls And All Settings; Clearing The Memorised Remote Controls - Fig - SOMFY ELIXO 3S M io Manuel D'installation

EN

8.2. Memorising the Keygo io remote controls

8.2.1. Via the programming interface
1) Press the "PROG" button for 2 s.
The screen displays "F0".
NB: pressing "PROG" again allows the next function to be memo-
rised.
2) Press the outer left and right buttons on the remote control together.
The remote control indicator light flashes.
3) Briefly press the button selected to control the function (complete
opening, pedestrian opening, lighting, auxiliary output).
The screen displays "Add".
COMPLETE opening control - Fig. 28
PEDESTRIAN opening control - Fig.29
LIGHTING control - Fig. 30
AUXILIARY OUTPUT control (P15 = 4.5 or 6) - Fig. 31
11
8.2.2. Memorising by copying a previously memorised
Keygo io remote control - Fig.32
This operation is used to copy the programming from a previously mem-
orised remote control button.
1) Press the outer left and right buttons on the previously memorised
remote control simultaneously until the green indicator light flashes.
2) Press and hold the button to be copied on the previously memorised
remote control for 2 seconds.
3) Briefly press the outer left and right buttons on the new remote con-
trol simultaneously.
4) Briefly press the selected button to actuate the motorisation on the
new remote control.

8.3. Memorising 3-button remote controls

8.3.1. A via the programming interface - Fig. 33
1) Press the "PROG" button for 2 s.
The screen displays "F0".
NB: pressing "PROG" again allows the next function to be memo-
rised.
2) Press "PROG" at the rear of the 3-button remote control to memo-
rise the function.
The screen displays "Add".
8.3.2. By copying a previously memorised 3-button mo-
no-directional io remote control - Fig.34
A = "source" remote control already memorised
B = "target" remote control to be memorised
8.3.3. Button functions on a 3-button remote control
F0 Complete opening
F1
Complete opening
F2
Lighting ON
F3
Aux. output ON
9. CLEARING THE REMOTE CONTROLS
AND ALL SETTINGS

9.1. Clearing the memorised remote controls - Fig 35

Press the "PROG" button for 7 s.
Clears all the memorised remote controls.

9.2. Deleting all settings - Fig. 36

Press and hold the "SET" button for 7 s.
Clears the auto-programming and resets all parameters to default values.
my
Stop Complete closing
If gate is closed à Complete closing
pedestrian opening
Otherwise à stop
Lighting OFF
Aux. output OFF
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
Elixo 3S M io