SOMFY GDK 700 Notice D'installation Et D'utilisation page 52

2 Programming
> Choice of docking zone when closing
1
• Press button A" repeatedly until
"A
activated.
• The number of times "N" that indicator light "B
the parameter, see table below).
Indicator light A
Indicator light B
WARNING
If this parameter is changed, it is essential to check that the obstacle detection complies with appendix A of standard EN 12
453. Failure to follow this instruction may result in serious injury, e.g. due to crushing by the gate.
> Choice of type of power supply
1
• Press button A" repeatedly until
"A
• The number of times "N" that indicator light "B
the parameter, see table below).
Indicator light A
Indicator light B
18
EN - GDK installation and operating guide - SOMFY
twice. "Docking zone when closing" mode is
Docking zone when closing
No slowing
Short slowing (default
value)
Long slowing
. "Type of power supply" mode is activated.
Power supply type
Mains power supply (default type of power supply)
Solar power
2
x 2 N x 2
• Press button "B" to change the value of
the parameter.
3
No reduction in speed at the end of closing.
The speed is reduced during the last 20 centimetres.
The speed is reduced during the last 50 centimetres.
2
x 5 N x 5
• Press button "B" to change the value of
the parameter.
3
N
Press the button A" four times to
exit the settings menu.
N
Press the button A" once to exit
the settings menu.