SOMFY GDK 700 Notice D'installation Et D'utilisation page 50

2 Programming
> Case 2:
(case during installation).
3
• Control the motor using button "A" (continuous pressure)
so that the transmission shuttle is engaged on the carriage.
to the previous movement.
Release button "A" before the motor exerts too much pressure on the door.
4
• Press button "B"
to launch the auto-
programming cycle.
The door performs a complete
Opening-Closing cycle.
During the auto-programming cycle: If the door is moving, the movement is stopped and auto-programming is interrupted
if any of the buttons are pressed.
16
EN - GDK installation and operating guide - SOMFY
x 2
If the auto-programming is
correct, indicator light "B"
goes out.
x 2
• Maintain button "A" depressed to bring the door to closed
position.
If the auto-programming cycle was not
successful, indicator light "B"
In this case, start a new auto-programming cycle
using "B".
x 2
.