INSTALLATION
1
1.1 Implementation of fastenings
Measure the distance "D" between the highest point of the door and the ceiling.
6
EN - GDK installation and operating guide - SOMFY
Case 1: Drive against ceiling
If "D" is between 35 and 200 mm, secure
the assembly directly to the ceiling.
D
Case 2: Drive not against ceiling
If "D" is greater than 200 mm, secure
the assembly so that the height "H"* is
between 10 and 200 mm.
* H = distance between the bottom of the
rail and
the highest point of the door.
determine "H" by subtracting 10 from 200 mm from "D". Then mark this value
on the lintel from the ceiling. The mark indicates the lower position of the
lintel bracket.
When installing, centre the assembly in
relation to the garage door.
When installing, centre the assembly in
relation to the garage door.
"D" has been measured,